 |
| All of my reference pictures |
 |
| I started with 2 pieces of foam board |
 |
| I drew out half of the statue body onto craft paper I made sure to have a nice round shoulder to support all of those arms |
 |
| Cut it out |
 |
| Traced both sides by flipping my template |
 |
| Cut out my statue body base out of one piece of foam board |
 |
| Cut out a slot for the body base to go into on the other foam board |
 |
| Both pieces put together |
 |
| Added two wedges for support |
 |
| The front |
 |
| More support. I used styrofoam to keep it light Cut out the hole for the cave entrance |
 |
| From behind, I'm leaving a boxed area for the cave to recess into later and for electronics to reside |
 |
| Added a layer of paper mache over the base just to add a little more stiffness Weighed down the edges to that they don't curl up on me |
No comments:
Post a Comment